Categories: All Technology FAQ News

What should be done if the Mission pump bearing overheats?

The key to resolving this usually lies in identifying whether it is a lubrication issue, a cooling issue, or a mechanical problem. You can troubleshoot by following the process below. Step 1: First, check lubrication and cooling These are the most common triggers and also the easiest to address. Lubrication check (the most frequent cause) Too much grease: This is a very common mistake. For pumps operating around the clock, a small amount of high-quality lithium-based grease every 500 hours …

Feasibility Analysis of Using Valve to Regulate the Flow of the Pump

Adjusting the pump flow rate by adjusting the valve is one of the most commonly used flow control methods. The principle is to adjust the outlet valve opening to change the pipeline characteristic curve, thereby adjusting the pump operating point to achieve flow control. Specific operation method: • Install a regulating valve on the pump outlet pipe. • Gradually reduce the valve opening to increase pipe resistance. • This causes the pump's operating point to shift to the left along …

Slurry Pump Selection

Slurry Pump Selection Characteristics of the Transport Medium (Slurry) Solid Particle **Particle Size Distribution: Maximum particle diameter, average particle size, particle size gradation. This affects the pump's flow passage clearances and clogging resistance. **Particle Hardness:** What is the hardness? Higher hardness particles are more abrasive. **Particle Shape:** Are they spherical, rhombic, or sharp/angular? Sharp, angular particles cause more severe wear. * Slurry Properties: * Concentration: Weight concentration (Cw) or volumetric concentration (Cv). This is a key parameter, directly affecting the …

Reasons for vibration of slurry pumps

The causes of slurry pump vibration are highly complex and usually result from a combination of multiple factors. These can be summarized into the following major categories: Rotor Imbalance: Causes: This is the most common cause of mechanical vibration. Due to uneven wear of the impeller (a typical issue in slurry pumps), foreign material buildup, or manufacturing defects, the mass center of the rotor does not align with its rotational center. Manifestation: The vibration frequency matches the rotational frequency (1X) …

Slurry Pump safe operating procedures

1. before the inspection 1) Check the direction of rotation of the motor is consistent with the direction of rotation of the pump (please refer to the corresponding model instructions). In the test motor rotation direction, should be a separate test motor, must not be connected with the pump test. 2) Check whether the elastic pad in the coupling is intact or not. 3) Check that the motor shaft and pump rotate concentrically. 4) handcart car (including motor) pump should …

List page last updated: